Quote:
Originally Posted by ljoncp
That is hardly a how-to video. Nowhere in that video does he say anything about how to do it.
Sorry but that is impossible to do on a drill press. Try a bridgeport.
|
You're right. It was very difficult with a drill press. The fact the hubs have 6 sides makes it impossible to clamp them in a vise with the pin hole vertical. I gave it a shot anyway. Some of the 17mm hub pin holes got a little widened (either due to bit wobble or some other crap), but I think they should hold up. I only had one pair of hubs at the time with another set on order. I'll have to drill those hubs out a little bit for the pin to fit and only time will tell if it all holds up.'
Anyway, here's one done.
Threaded Mode
