TT MTA4 S50 conversion

[j.f.s]

Sure, but the stub axles aren't threaded apart for the very tip of it. The hexes slide on the 6mm axle and are held in place by a pin. Like on the 14mm Traxxas or HPI axles. I'll take some pics later on to better illustrate what I mean. :)



I think I may have missed your point a bit there Brian. I just assumed that all adapters/hexes has the support for the rim since Axial ships adapters with their rims and those adapters has extra support for the center of the rim. I could buy HPI's E-savage hexes since the flanged nut HPI provides has the support for the rim built in to them.

[brian015]

Originally Posted by j.f.s

I could buy HPI's E-savage hexes since the flanged nut HPI provides has the support for the rim built in to them.

Yes, those are the type of nuts I was thinking would be used with these - since you are using the threads on the axle to hold the wheel on - instead of other hex designs that hold the hex on with the axle nut and then use another nut (17mm) to hold the wheel on.

So you could just buy the HPI nuts and use them with these hexes, right?