Emaxx mechanical brakes...---DONE---

[nitrostarter]

I've done this multiple times. Still no brakes. Its in a different mode, i think, that needs the cable to change.

In fact I just went try it. I tried to make it For/Brake/Rev and still no brakes. I tried to make it For/Brakes, and stil no brakes.

[rchippie]

Do you have any pics of the completed install this sounds very promising ?. Thank's

Are all the 9920's the same?

[nitrostarter]

I run a Micro 18120, not the 9920.

[coolhandcountry]

You should be able to program it by the remote. If you plug it up and wait for the main beep the go foward for a beep then back to neutrel for the final beep.

[nitrostarter]

Is it possible to have like the braking part burned up? The controller runs fine otherwise, it just doesn't have brakes.

And like I said, I've tried reprogramming it multiple time and still the same, no brakes.

[coolhandcountry]

well it is possible to have it not in car mode. You need the cable to change that part. I tried one and it didn't have brakes.

[Serum]

Did you checked your EPA on the transmitter?

[nitrostarter]

Yep, tried it with the Hitec Radio I use and with the stock TQ3. Still no brakes. I think its just that Im in a different program.

[squeeforever]

sounds like its in boat mode. if im not mistaken you can program it for forward/reverse or am i just dreaming? nitro, wasnt it going into reverse when you tried to brake?

[nitrostarter]

Its in a For/Rev mode. No brakes, however, the truck must be completely stopped before it reverse.


If I can get this Mech. brake cleared up, I'll try it.

Picture of mech brakes installed on transmission:



Pic of my lot of stuff:



Pic of everything included:

Consider a trade for a Gen 2 aluminum Ultramaxxed second gear?

[nitrostarter]

Have you run this yet, tested it yet? If so, how well do it stop the truck?