 |
|
|
|
 |
|
|
 |
 |
|
 |
|
(#1)
|
|
RC-Monster Stock
Offline
Posts: 18
Join Date: Jul 2015
Location: SE Minnesnowta
|
07.20.2015, 08:08 PM
I used Associated #89575 82mm (front) Associated #89576 108mm (rear) dogbones. RCM slipperential with Traxxas 6mm drive cups in the center and Mugen MBX7T diffs with UE 5mm drive cups on the pinions. That setup gets me about 2-3mm of end play on each bone.
|
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
RC-Monster Carbon Fiber
Offline
Posts: 235
Join Date: Nov 2012
Location: The Netherlands.
|
07.21.2015, 11:08 AM
May I ask why you use two different sizes cups?
Don't you have a lot of play in the 5mm cup? Or is the 5mm the bore size Wich slides over the pinion? |
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 6 (0 members and 6 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
