EMaxx chassis

[kjf73]

Yessir ...ordered the Associated dogbones just have to wait for them to land here in DK! Major busy at work again so will probably be a while before I have it built..:-( still patience is a virtue right?

[ruudxd]

If it a bit to long end to end, can't you dremel a little bit off the ends?
Just a mm total?

[Buzzsaw46]

Originally Posted by ruudxd

If it a bit to long end to end, can't you dremel a little bit off the ends?
Just a mm total?

In my build the pinion shafts would be the best place to gain a bit of space, the HB have a pretty long pinion shaft.

[kjf73]

Sooooo.. Progress on my build..still waiting on front dogbone as unfortunately the Associated one was just a hair too short

Going with RPM bulks and stock diffs for the moment due to budgetary constraints (she who must be obeyed )
Should be ok as plan to start with 4s while I get to know the beast..

Had to put her in roller just to see those Big Joe 2 badboys

[kjf73]

And...

[kjf73]

.....

[kjf73]

She pretty ...