BL Revo

Dafni,

First, I must say that your Revo looks awesome! Very nice work!

I just got my Revo today, and have already removed all of the components that I won't need, to convert it to Brushless.:D I will be using my Plett MAXXimum and Schulze 18.97, from my E-Maxx, to power this new beast! I would like to know if you had to replace the short front center driveshaft with another long rear center driveshaft to fit the E-Maxx tranny? When I test fit my single speed E-Maxx tranny, it appeared that I would need another long center driveshaft to make it work. Also, I noticed that the output shaft, from the tranny, doesn't fit all of the way into the Revo driveshaft yoke. Did you file the end of the output shaft to fit, or did you open up the inside of the yoke?

Thanks.