Quote:
|
Originally Posted by AAngel
The second was the lack of a flat machined into the shaft to accomodate the set screw of the pinion. Is this normal or did I get the wrong motor?
|
I've never gotten a motor (besides the Castle motors) that had a flat spot on the output shaft. Just put one on there yourself. My preference for doing it is a Dremel.
SH Z-Car, Custom Crawler, 8s Savage,
12s XTM XLB 1/7 buggy,
4wd 4-link rear/IFS Pro4 truck,
Custom Hyper 10 Short Course,
Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
Threaded Mode
