Ofna Hyper ST Conversion!

[BL_RV0]

Dang...

[Pedebeater]

Like I said, you should get it early-mid this week. I hope you like it.

[BL_RV0]

I will...

[Finnster]

Hope to see you get everything going. I think this is the longest build thread I've ever seen that still does not have a running truck by the end. lol

20K is def very good in the center. It ran really nice and not much ballooning in F. I think I have 7/20/3. I did put one step higher springs in the F as well.

I really like this truck. Turns on a freaking dime. I think it has a smaller turn radius than my CRT.5.

[BL_RV0]

I've been having an unruly amount of problems getting it working... Hopefully I can use my 10t pinion for a low speed test.

[Arct1k]

I dropped from 25 to 10k in teh centre and am preferring it - Still no significant ballooning..

[BL_RV0]

I hope the 600 shows up today.... I'll test it with the one hardened pinion I have- 10t. I'm going to pick up a 16t from Mike this week.

[NIKER]

Hi, veiw to my conversion. not finished but will soon be.

http://n4ker.rajce.idnes.cz/E-HYPER_8_ST/

Radio FUTABA 3PM 2.4Ghz
- Servo HS-5645MG
- ESC MGM 160A
- Motor ALIGN 600XL 1650kv 700W
- Battery 5s/20c 5000
- battery tray Aluminium profile + Gorillamaxx Strap or tekno rc strap
- Gearing 12 or 14-15/52 (5s)
- Diffs 7k 10k 3k
- Shocks 45w

You do not know about hardest shock spring?

[BL_RV0]

Nice conversion. It has many of the same components that mine does.

[NIKER]

Originally Posted by BL_RV0

Nice conversion. It has many of the same components that mine does.

THX, your conversion is too good. I use only tested parts...
Do you have a video of HYPER in action?

[NIKER]

Why 16T pinion, will not be too heavy a transfer?

[BL_RV0]

That makes speed around 40mph, optimal for brushless general bashing.

[BL_RV0]

I got the pinion ordered from the lhs. Will be in tomorrow. Gave the motor a test unloaded with a max of about 1/8 throttle. God, it sounds AWESOME! I relocated the MM to behind the motor, and wired up the bec. The way I mounted the bec is a but ghetto, just tie-wrapped it onto the esc power wires. Also, got the front brace mounted, finally. Here's a couple pics:

[Pedebeater]

Looks good man. You will have to post a vid once you get it all done, I never did get to enjoy that sound of the motor. lol

[BL_RV0]

I'll try to make a "motor sound" video today if I can get a hold of the stepdad's camera.