Any interest in a Ballistic 550 Motor?

[NovakTwo]

Originally Posted by snellemin

2500kv

Sounds like an 8.5 wind? We may also add a 3.5 wind.

We will also be offering a Build-A-Ballistic 550™ program.

[ta_man]

Originally Posted by NovakTwo

Sounds like an 8.5 wind? We may also add a 3.5 wind.

We will also be offering a Build-A-Ballistic 550™ program.

What would be the rated kV of an 8.5HV?

[NovakTwo]

Originally Posted by ta_man

What would be the rated kV of an 8.5HV?

Not sure, but it may be as close as we can get to 2500 Kv. I'll see if Bob has measured it.

[snellemin]

Sounds good. I'll wait for both.

Yes!

So would these lower kv motors do fine on higher voltages? Judging by the rpm limits, I would think the 8.5 would do ok on 6s.
Would the build a balistic include the option of the 14mm rotor, without buying the 12.3?

[NovakTwo]

Originally Posted by asheck

So would these lower kv motors do fine on higher voltages? Judging by the rpm limits, I would think the 8.5 would do ok on 6s.
Would the build a balistic include the option of the 14mm rotor, without buying the 12.3?

I will have to check on the higher voltage uses.

The B-A-B would offer a selection of the wound stators, rotors and harness length. Later, we may add ceramic bearings as an option.

Originally Posted by NovakTwo

we may add ceramic bearings as an option.

THIS is a MUST. You've got to get this done.