1930/10 / 12020

[BrianG]

Originally Posted by squeeforever

NewEuser, have you tried the 1930 with the 1930? After having problems with it on 2 ESC's, I might be scared to try it though :005::005:.

Huh?

[Gustav]

He means the 9920 i think,funny though,motors don't run each other too well:005:

i wouldn't try it though,sounds like a short or something in the motor.

[neweuser]

Well i sent the quark back :o( thinking it was the prob, i ran the 12020 with the 10xl, and all it does is stutter, put the 9920 back in, seems good again so far! same set up i started with before the lehner! ALL I CAN SAY IS 685.00 and back to start! I'm a little TICKED?!?!?!?!??!?!?!?!?! yeah a little! I'm sure the 12020 is gone, but i think that the quark may be ok....The motor was used, and the bearings seemed fine, but the back lash i found...it's f'n terrible..read above for the description for it!

[neweuser]

OK, after doing a few runs, my old system runs like a dream as usual. There's the answer folks.

[BrianG]

Originally Posted by neweuser

OK, after doing a few runs, my old system runs like a dream as usual. There's the answer folks.

What's the answer?

[sjcrss]

running the 9920 with a 10xl...

[BrianG]

Why would going to a 9920 from a 12020 or 125B be the answer? That's odd.

[squeeforever]

The answer is that his 1930 is the problem.

[neweuser]

Yep, thats the whole reason. The motor was the problem which is why the Qaurk was getting so hot, but i don't think the Quark was fried, but i think 12020 may have been a bad esc. it never had mid range and it fried my ubec. so i put the 10xl in and the 9920, and everything is back to where i started! ARRRRGGGGGG! The whole idea was to have a better system, but now i just have the same as i was running.

[coolhandcountry]

The 1930 came from me. I had it on a 7020 on a flm maxx. I ran the motor about 6 packs before the esc smoked the capacitors but still worked. I could get 20 mins of consistant run time with it. It would over heat the esc if run hard.

[neweuser]

Unfortunately i couldn't get two min out of it...It's all good, nop hard feelings...I would do it again though CHC, you are an all right guy!

[neweuser]

I would do an edit, but this needs to be said by itself.
I was never mad at CHC, he is an outstanding gentleman and is word worthy, and trust worthy. It was the sitch that was frustrating. Just needed to clear that! I hope you guys understood that!

[coolhandcountry]

The only thing I can think of is. When I had it on the 80b quark and it fried it surged the motor and messed it up. I never ran it after that. I think it may be covered under warranty. I liked that motor to.

No problem neweuser. It is frustrating for both of us. I have no problems working with you.

[neweuser]

Thanks CHC. Let me know what you find out. Thanks guys

[tallyram]

looks like you're rubbing off on me, neweuser. i'm having to buy controllers until one works. i'm trying the 125b now! have you sent the 12020 back yet?