Assemble a brushless GMAXX

[Sylvester]

Jagboy, i dont know where you've seen this but ive seen TONS of succeses with the 9920.. Only 2 or 3 that have fried the 9920, it really depends if it is all wired correctly and used properly, and if all is in order and it doesnt work, than it must have been a faulty controller ~ you didnt try a 2nd 9920, did you? It could have been a faulty controler..

TruckBasher, regarding arms, They both have complete hardware, but since you need extra money for lipo, the flm arms are very nice for bashers as well!

[TruckBasher]

BTW, (sorry OT) for the lipos i read this part

3S2P pack to use on the non-motor side and a 2S2P on the motor side
http://www.rc-monster.com/forum/show...95&postcount=2

I also want to run 5S on a 9920 8XL setup do you think its good or should i reconsider. What is the best way to set thi up.

BTW, Mike finally replied to my email. I am just asking him if he can help me with the other hardware needed to assemble this truck then i am off....ohh that is if i decide to lipo or not to lipo

[jagboy]

I must be tainted by the fact that everyone posts when they fried a controller and not when it's working. I've seen at least 10 threads about people frying a 9920. I might have just gotten a bad one, but I still stand by most of my statement. I'm much happier with my MM than I would be with a working 9920. Its small footprint, conventional box casing, programming, and the customer support especially make it worth, to me, the 8 cell cut. It has no problem moving my Savage around and if I find the money to get an 8XL and a fan it will be plenty fast for me. I'm sorry if my post seemed biased, as I probably unintentionally (and unfairly) was. If you really want the 20 cell capabilities, get the 9920. Who knows, maybe in the summer you can upgrade to the Monster Max which should be better than both of these.


JB