First Neumotor

OK, i came to the conclusion that they don't have any real good ESC
We can pay $300.00 or $500.00 for an ESC and that's not a proof that the ESC will be better than a cheap $100.00 one.
My friend have run a brushless LST2 with a Nemesis Blue and a MM on 4s, all summer long, without any trouble...... And the LST2 is way heavier than the Maxx or revo!!!

[gixxer]

I think that the first thing everyone notices when they go to the neu from a feigao. I remember thinking the same thing when I tried to spin the neu for the first time.

[aqwut]

if it was a two pole motor, it would spin freely....

[crazyjr]

Originally Posted by aqwut

if it was a two pole motor, it would spin freely....

Using the Neu, pletty, novak design, it will still turn rough. That is the design of the slotted (or caged, as i called it before knowing it was called slotted). Its the web the windings are wound on that make it rough to turn.

[DrKnow65]

My new Ammo motor (35-50-2300kv) turns mich tighter than my old cc36-5700kv motor. I'm pretty sure it's the "dual sealed" bearings. I've ran it a few times now and it's starting to free up a bit, would imagine the lower kv windings would have less magnetic drag? or am I thinking about it wrong? or do the windings not have any effect on magnetic drag, just the magnets themselves?