RC-Monster Forums - View Single Post - Future: Brushless 1/8 Buggy *CAD Renderings*

SilentMonster · 04.07.2007, 11:22 PM

What about putting the motor in the center down on the chassis with the center diff above the motor. That would lower the COG. I had thought of that when I was laying mine out. I was able to keep everything down on the chassis with a different design. I used only one battery though. It could be off to the side and above one of the batteries. The drive shaft angles should work fine. I had mine mocked up like that and it looked like it would work all right.

	(#9)
SilentMonster RC-Monster Stock Offline Posts: 46 Join Date: Feb 2007 Location: Hillsdale, MI	04.07.2007, 11:22 PM What about putting the motor in the center down on the chassis with the center diff above the motor. That would lower the COG. I had thought of that when I was laying mine out. I was able to keep everything down on the chassis with a different design. I used only one battery though. It could be off to the side and above one of the batteries. The drive shaft angles should work fine. I had mine mocked up like that and it looked like it would work all right. "MAKE EM CRY"