RC-Monster Forums  

Go Back   RC-Monster Forums > RC-Monster Area > General Discussion

Reply
 
Thread Tools Rate Thread Display Modes
lipo wont stay in balance?
Old
  (#1)
stampy
RC-Monster Carbon Fiber
 
stampy's Avatar
 
Offline
Posts: 471
Join Date: Aug 2005
Location: Dallas Or.
lipo wont stay in balance? - 09.11.2006, 01:07 PM

ever since the first day i got my pack (hyperion 3700 3s) it wont seem to stay in balance. after every run it is in stages from a min imbalance to a big imbalance, i can charge it at any thing over .5 amps or it will charge imbalanced, no matter if im charging through the balancer or not. i love the power and the lightness but this is a pain:mad:1 . what could be going on.:019:
   
Reply With Quote
Old
  (#2)
neweuser
RC Monster, the Final Frontier
 
neweuser's Avatar
 
Offline
Posts: 3,379
Join Date: Feb 2006
Location: Minnesota
09.11.2006, 04:41 PM

Bad cells??


"if you've got something to say, say it peacefully"
  Send a message via MSN to neweuser  
Reply With Quote
Old
  (#3)
squeeforever
RC-Monster Mod
 
squeeforever's Avatar
 
Offline
Posts: 6,254
Join Date: May 2005
Location: Baton Rouge
09.11.2006, 05:59 PM

Thats what I would think...
  Send a message via AIM to squeeforever  
Reply With Quote
Old
  (#4)
MetalMan
RC-Monster Mod
 
MetalMan's Avatar
 
Offline
Posts: 5,297
Join Date: Mar 2005
Location: SoCal
09.11.2006, 10:49 PM

That's usually the problem if the cells were initially properly matched. My main 4s Lipo pack has a similar problem. I'm pretty sure that it was caused by it falling on the floor, since the cells that hit the ground are the ones that show the imbalance.


SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
   
Reply With Quote
Old
  (#5)
BrianG
RC-Monster Admin
 
BrianG's Avatar
 
Offline
Posts: 14,609
Join Date: Nov 2005
Location: Des Moines, IA
09.11.2006, 11:05 PM

Quote:
Originally Posted by MetalMan
That's usually the problem if the cells were initially properly matched. My main 4s Lipo pack has a similar problem. I'm pretty sure that it was caused by it falling on the floor, since the cells that hit the ground are the ones that show the imbalance.
Do you mean "...initially improperly matched." I don't want to argue semantics, it's just for us non-experienced users...
  Send a message via Yahoo to BrianG Send a message via MSN to BrianG  
Reply With Quote
Old
  (#6)
MetalMan
RC-Monster Mod
 
MetalMan's Avatar
 
Offline
Posts: 5,297
Join Date: Mar 2005
Location: SoCal
09.11.2006, 11:41 PM

I meant that damage to the cells is sometimes the cause of imbalance assuming the pack was initially matched (cells' IR and capacity).


SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
   
Reply With Quote
Old
  (#7)
BrianG
RC-Monster Admin
 
BrianG's Avatar
 
Offline
Posts: 14,609
Join Date: Nov 2005
Location: Des Moines, IA
09.11.2006, 11:48 PM

I see. It read a little funny, but now I can see what you are saying...
  Send a message via Yahoo to BrianG Send a message via MSN to BrianG  
Reply With Quote
Old
  (#8)
stampy
RC-Monster Carbon Fiber
 
stampy's Avatar
 
Offline
Posts: 471
Join Date: Aug 2005
Location: Dallas Or.
09.12.2006, 03:20 AM

lame, theres 140 bux down the drain :031: they probably take them back since there a few months old.
   
Reply With Quote
Old
  (#9)
neweuser
RC Monster, the Final Frontier
 
neweuser's Avatar
 
Offline
Posts: 3,379
Join Date: Feb 2006
Location: Minnesota
09.12.2006, 04:18 PM

i would contact them before thinking it's down the drain. They may assist you. Where'd you get'em?


"if you've got something to say, say it peacefully"
  Send a message via MSN to neweuser  
Reply With Quote
Old
  (#10)
stampy
RC-Monster Carbon Fiber
 
stampy's Avatar
 
Offline
Posts: 471
Join Date: Aug 2005
Location: Dallas Or.
09.13.2006, 10:45 AM

i got it from cheapbatterypacks.com i dout they will help since i just noticed the pack has puffed and has a dent in it :019:
   
Reply With Quote
Old
  (#11)
neweuser
RC Monster, the Final Frontier
 
neweuser's Avatar
 
Offline
Posts: 3,379
Join Date: Feb 2006
Location: Minnesota
09.13.2006, 10:59 AM

Contact Mike at cheapbattpacks, he is actually a very good guy. See what he says....he may help you out? He replies very fast.


"if you've got something to say, say it peacefully"
  Send a message via MSN to neweuser  
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com