stronger gerboxes or dd-outrunner in ax10 clone?

[speedy]

I mounted a 35x48 outrunner in the gerabox in my hsp pangolin (ax10 clone)
and after 2 min runtime onewheel got stuck an i bliped the trottle and CRUNCH" and the top two geras inside the cenrer gearbox stripped out :(
are there any bulitproof gearboxes that would fit ?
the center driveaxles are traxxasstyle telescope shafts made for 5mm output shafts.

i think that the most durable sulution would be a outrunner in direktdrive
i have a bigger motor 42x50 850kv ,with 5mm shaft would this bee enough ?

this is an 2.2 crawler

[Arct1k]

Just use an AX10 trans and Robinson steel gears...

[speedy]

were can i by those items ?

[Arct1k]

Axial do them for $50, RPP do them as do HR

http://www.rpphobby.com/product_p/hotsscp1000t.htm

http://www.rpphobby.com/category_s/28.htm

[ta_man]

Originally Posted by Arct1k

Axial do them for $50, RPP do them as do HR

http://www.rpphobby.com/product_p/hotsscp1000t.htm

http://www.rpphobby.com/category_s/28.htm

Chris,

That Hot Racing gearset from rpphobby has a "52T" marked on it. That's the same number of teeth on a B4 2.6 trans and RC10GT 2.6 trans diff gear. Do you know if these gears will fit in those associated cars? Ever tried fitting gears from the Axial trans in Associated gearboxes?

[Arct1k]

It looks like it is not an exact clone - just ax10 like.

Honestly - I'd get rid of it and find a used ax10 or you could keep axles and put an ax10 trans in.

CKRC has a complete metal trans and case for a reasonable price.

[speedy]

an axial gearbox with metallgears costs more than my crawler rtr ! so no thank's

the gearbox +gears costs 250$

here in sweden that is !