Center Dog bone fit?

[mkrusedc]

I installed 70mm center dogbones in my E-maxx. There seems to be alot of play in them. The pin sits just short of halfway into the cup. Shouldn't it sit in the deepest 1/3? Is this normal or should I get some a little longer?

[GorillaMaxx360]

put a piece of fuel tubing inbetween the ball and and ball cup and that will not allow for so much play and you will be good.

[GorillaMaxx360]

you could get 72mm if you wanted but fuel tubing(spacers, washers, orings) is cheaper and will do you the same performance.

[mkrusedc]

Thanks. I am learning that fuel tubing can be used for alot of things in an electric RC

[mkrusedc]

Would these work?

[GorillaMaxx360]

it does not say the diameter so they may be small but they should work. any type of spring will work too. try a pen spring and cut it to size. anything to shim the distance really will work.