Mmm2 slow take off. No full throttle starts

[outlaw]

Thomas

just installed Firmware 1.45 on my MMM (not the V2)

The response of the first 2% of throttle is more like switch
The car does not jump start like on previous version, but still not as good as on the 1.24 MMM Firmware, this version allows "Crawler Like" startups

Setup
Kyosho DRX
MMM
CC 1410 1Y
geared for about 30 mph
Tekno RC Traktion Drive (Slipper Clutch)
Timing "0"
Start Power Low

Here is video with Version 1.45
MMM @ Firmware Version 1.45

Version 1.24

MMM @ Firmware Version 1.24

I pulled the throttle careful just like you would drive out of the pits
On 1.24 is really depends on the position of the rotor how smooth you can start, but still 100% better than anything after this version

Hope that helps
Soory for the poor videos