BK Micro controller and Neu Motors?

[jhautz]

According to the manual on the BK site the RPM limits are like this:

RPM:
ca. 100,000 rpm with 2-pole motor
ca. 50,000 rpm with 4-pole motor
ca. 25,000 rpm with 6-pole motor

But then, I also found on the BK web store that says "[B]all BK-Controllers are made for 2 pol brushless motors !
I dont plan on going over the 50K limit on the neu which is a 4 pole motor.

I already have a few quarks but was thinking about trying the 3695 so I could run a higher voltage setup. Something like 10s. At least 6s which is ify on a Quark. Anyway it was just a thought. I probably wont be doing anything with it for a little while. Just thinking at this point.

What is this instant brake thing after letting off the throttle? Sounds really stupid.