My new home made center sliperential

A 22T is 24mm diameter, and the 23T should be 25mm.....Hummmmmm!!! it's a full 0.5 mm all around, so i think that it'll be to tight, but if somebody have a 23T for me, i'am ready to try it.
Because i don't want to order just a pinion from Mike, it'll cost $25.00 just for shipping

I've try the gear mesh with a Kyosho 46T plastic spur and it was not to bad, but with the steel one, the mesh seam to be a litle on the loose side.
Maybe it's the theet shape of the steel one that's not the same.

[lincpimp]

It may be ok, I usually set my steel to steel gears slightly looser than stell to plastic. They seem to run smoother with a bit more slack, and are plenty strong.

Originally Posted by lincpimp

It may be ok, I usually set my steel to steel gears slightly looser than stell to plastic. They seem to run smoother with a bit more slack, and are plenty strong.

That's what i think, so i'll be try it.
But your idea of a 23T is not bad, i'll try to find a 23T just to test the mesh!

[lincpimp]

Hope it works well, let us know!