Cc/neu Motors

[Pdelcast]

Originally Posted by Metallover

hmm...

Still saying Neus will kick cc/neus A$$.

You never know if CC will use cheap materials on the motors...

Well, I can tell you:

Materials: Source:

Bearings Japan (Koyo - CNC grade, 100K RPM rated)
Laminations M19 non-oriented magnetic steel Japan
Magnets Same as Neu - China
Shaft material Stainless - USA
Case T6061 - China


So sorry, no cheap a$$ materials here.

The CC/Neu motors will meet or exceed the performance of the Neu 1515.

[tc3_racer_001]

again will you sell them seperately? id happily buy the 1512 2d :D

[e-mike]

Originally Posted by Pdelcast

Well, I can tell you:

Materials: Source:

Bearings Japan (Koyo - CNC grade, 100K RPM rated)
Laminations M19 non-oriented magnetic steel Japan
Magnets Same as Neu - China
Shaft material Stainless - USA
Case T6061 - China


So sorry, no cheap a$$ materials here.

The CC/Neu motors will meet or exceed the performance of the Neu 1515.

good!!!i can't wait for the release of those beastmmm+cc motor =fun

[lincpimp]

Originally Posted by Pdelcast

Well, I can tell you:

Materials: Source:

Bearings Japan (Koyo - CNC grade, 100K RPM rated)
Laminations M19 non-oriented magnetic steel Japan
Magnets Same as Neu - China
Shaft material Stainless - USA
Case T6061 - China


So sorry, no cheap a$$ materials here.

The CC/Neu motors will meet or exceed the performance of the Neu 1515.

Thank you Patrick for the info. Do you plan to make all of the various winds? I only ask because it would appear that your motors will sell for less than the neu motors, and if they are just as good, who would buy a neu?

I will say that the motors appear to be geared for the car market, so the heli and air market will still want the original neu motors. You did mention that the cc motors will be heavier and have more car-oriented specs in the case design.

I am guessing the price will be kept low due to the quantity produced and sold...

Now, how about some neu design based motors to replace the cm 36 motors, with 80-100k rpm potential, please!