My new FLM Savage X SS

[killjoyken]

I was running it on 4s for a while since I had to go back to a MM while my MMMs were back at Castle. Then I did a complete tear down and rebuild, cleaned everything, and replaced some tweaked parts. BTW, the 3-speed is still perfect.

I'll post some new pics when I get everything back together.

[MTBikerTim]

Originally Posted by killjoyken

I was running it on 4s for a while since I had to go back to a MM while my MMMs were back at Castle. Then I did a complete tear down and rebuild, cleaned everything, and replaced some tweaked parts. BTW, the 3-speed is still perfect.

I'll post some new pics when I get everything back together.

Have you got those packs Velcroed together so the cant slide forward and damage the plugs?

Yes, Ken has the batts velcroed together, in one of the previous pics, u can just barely see it, it also says it somewhere near the pic.

[killjoyken]

Finally put my Savage back together last week with a few changes. This one is built for top speed/drag racing and I'm building a 2nd FLM Savage for bashing. This one's got HPI Phaltlines, HPI big bores, and a Tekno Neu 1515/1.5d powered by a MMM V2 w/CCBEC. I ran it on 4s to tune the suspension and it was doing pretty well.....until I lost control at about 50+ mph and slid sideways into a curb. Amazingly I only put a small crack on the inside of the rear wheel and bent the crap out of a rear CVD.

Pics:





Monster Max mount for quick fan replacement as well as keeping the case from popping apart. It also doubles as a flame guard for my lipos!