Strobe slipper

[neweuser]

OK, as long as they line up and i use lock tite. the reason why i asked is because with my robinson, i burned a few not putting them in right. learned a lesson after two. general rule with those was dish down dish down, so when i saw the confilcting pics...hmmm, made me wonder!! thanks again! Not to go off the subject here, but where did youguys mount your controller on a stock chasis? my wires aren't long enough to make it the motor if i mount in the rear...so i did a mod with an old shock tower body mount and the novak motor hole cover to lay the controller on top next to the motor...i wish i could get my pics going, it might work good!!! i'm worried about interference as it's real close to the reciever....motor wires that is...