Brushless TLT

[rckcrwlr]

Originally Posted by sjcrss

i'll be running moabs, and how hard is it to cut them in the star pattern, it doesn't look to hard

It depends on how precise you want to be. I just use a sharp razor blade. I lay the foam on it's side and cut down. You could measure them out. Make sure you leave enough material in the center to keep it round. Make the points of the stars sharp so that when the BB's roll around the don't get hung up on them.

[sjcrss]

you still need to run the BB's as well, man this is turning into a pita.....ugh

[rckcrwlr]

Originally Posted by sjcrss

you still need to run the BB's as well, man this is turning into a pita.....ugh

Funny you say that...I am thinking the same thing with converting my Savage to BL.

It is all in what you want and need to do. If you are running beadlocks it is easy to adjust. If you are CA'ing the tires, don't glue them completely until you have it right.

[sjcrss]

no beadlicks, but will be gluing them, so thanks for the tip

[sven]

This is what I did for my foams:
I cut them in half and then did the pattern around the diameter. I don't run BB's, but I may try airsoft BB's once I get the Axial beadlocks.

[Sylvester]

Thats neat!
What did you use to cut them like that, scizors(sp?) are a pita to cut foams with. Very innacurate.

[GorillaMaxx360]

they cut there foams for there rock crawler in rc car action.

[Sylvester]

Ok. Thanks.. i think lol.

[sven]

I used a swiss army knife to cut my foams :)

[Sylvester]

Wow! Random! Thanks, that must take some steady hands.. :p