Muggy diffs in a maxx

[its me]

Thank you guys!! I cant wait to see this thing run aswell!

[mriccucci]

Keep up the good work man. I got some drive shafts yesterday and got everything together today but i think im a little long. My main purpose was to run my truck in the truggy class but im a little over 16" wheel base with just about 23" overall length. What driveshafts did you use It's me?



I was also wondering if you have some shputs of how you ran the steering setup?

[suicideneil]

http://cgi.ebay.com/T-MAXX-DOMINATOR...QQcmdZViewItem If you fancy a massive short cut....

[mriccucci]

Well no need for that now, all i have to do is decide on braces and a chassis width. I have the main part of the chassis laid out with the centerdiff and front and rear bulks in place.

[_paralyzed_]

its me or mricucci- any progress? I've been watching!

[its me]

Originally Posted by _paralyzed_

its me or mricucci- any progress? I've been watching!

LOL im almost done, all I need are the monster maxes. I need one to get the foot print so I can cut some carbon for its tray, after I do that then most of the parts are going to MRpaintin.com to get black anoed. Only the diffs and chassis are going to stay silver :)

EDIT* sample of Matt and Ross's work:)
http://www.rc-monster.com/forum/show...502#post164502

[mriccucci]

Originally Posted by _paralyzed_

its me or mricucci- any progress? I've been watching!

I've also been busy, im deffinatly not very good with the jigsaw and dremal but i think i may be able to get a local guy to laser cut another chassis plate.





My plan is to make some plates to go from the braces to the bulkheads like its me did. I think i may extend them a little on each side. Im going to cut the chassis dont a lot more, prolly about 5-7 inches wide. I've got 14.5 inches of wheel base so im just about at the truggy lenght. The only thing i need now is to find a body that would fit.

[_paralyzed_]

looking good

[its me]

would any one happen to know the foot print of the MMM???

[SnoopMaxx]

This is one of the the single motor mount
Electric Motor Mount HB Stadium 10

And the twin motor mount is from an E-Maxx 3906
Traxxas Motor Plate E-Maxx

Traxxas Motor Plate Custom E-Maxx

Trinity Motor Mounting Plate E-Maxx

[suicideneil]

Yep, they are. I think you need the stiffest springs really, since you are only running four of them, although it will depend very much on how heavy it is once all is said and done.

[jayjay283]

lol the newest member of the grape gang

[mriccucci]

Im actully thinking of using the fron springs on the rear, I have the collars down all the way and i was thinking it wouldnt be so bad to run These

[suicideneil]

Hmm, if those grey ones are the stock front springs, I wouldnt recommend them, especially on the longer rear shocks. They are not as stiff as you'd expect- rather squishy to be honest

[mriccucci]

Im pretty sure the stock are silver not gray at least i hope