X1CR brushless conversion completed!

[yj-7]

Here is a pic that shows the layout a little better. One of my goals when I did this project was to leave the center diff where it was and to fit the components around it and still keep a good center of gravity and be well balenced. The only extra holes that where drilled and tapped are the holes for the batt tray and they are in the chassie stiffiner. It jumps great and even turns better than I expected. I have a Xray XB8 nitro that I run and it turns better than most others I have driven so I was a little worried about the jammin not turning as well but it is very close.:013: :027: