Quote:
Originally Posted by david lamontagn
No, i don't have mill, i must go on a machine shop to do the job, and it cost a lot of $$.
Just to make the hole3 for the 4 bearing, it cost me $96.00 
The bearing for the top sliper shaft is 5x11 and those for the diff are 8x16. |
Jesus, 96 bucks! I am lucky to have a local machinist that helps me out with small stuff. The last few things he did were free! I have him do a fair amount of stuff on my various gun projects, plus he is laid back and only really works cause he would get bored.
Nice looking work David. I am planning something similar for the revo I just built. It has the hybrid diffs I got from you, and will have a center diff with the integrated slipper, as soon as Mike starts selling them! I will have to make some custom bulkheads, but will most likely have the machinist make the whole deal. I will just design it, not very difficult!
Threaded Mode
