my E revo in maxx-style

[ncnguyen123]

I saw a post from stumblin on putting in new emaxx tranny. Was it hard for you putting it in? From his post, it looks like you have to cut a big groove for the spur and then some of the side for the tranny to fit. Is this right? Also, how did you fasten the tranny...drilling 4 new holes and using big washers?

I like to do this mod as I have a new emaxx tranny on the way.

[_paralyzed_]

I love seeing that e-maxx with the plettenberg all covered in mud! Too many people baby their trucks. Nice work.

[rhylsadar]

hi

its no big deal to mount the tranny in the revo chassis. you just have to find a good position for it. drilling the holes and just a little dremel work for the spur. my tranny is sitting a tad higher as you can see in one pic above with those yellow washers. so there was very few dremeling for the spur. i have to made a cover to protect it a bit form the dirt.
in the traxxas forum there is a guy who made some sort of tranny holder with two revo chassis braces. that looks good. you may check it.

bye
rhlysadar

heres a emaxx tranny mounted in the revo...those motors are for moc-up...i'm going to run V-twin with two maxamps 3s 8000mah lipos...I hope to hit at least 50-60mph
http://www.rgcbuilders.net/revo1.jpg

http://www.rgcbuilders.net/revo2.jpg

http://www.rgcbuilders.net/revo3.jpg