cut a flat spot in shaft for the pinion set screw? - RC-Monster Forums

		RC-Monster Forums > Support Forums > Brushless
cut a flat spot in shaft for the pinion set screw?

Rate Thread

Prev

Previous Post

Next Post

Next

	(#16)
mkrusedc NeuMaxx Offline Posts: 1,286 Join Date: May 2007 Location: Near New Orleans	04.10.2008, 05:19 PM I haven't put a flat spot on my Neu yet. The pinion came off twice before I used loctite. So far no problems, but I am a basher. If mine comes off I won't lose a race. I have used a soldering iron to heat the grub screw and then used a pinion puller to get stuck pinions off. E-Maxx Neu 1515/1y/f, MGM, 5s, FLM, UE, RPM, single speed Last edited by mkrusedc; 04.10.2008 at 06:30 PM.

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Forum Rules

Forum Jump

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com