|
07.09.2008, 07:39 PM
For what it's worth, I opened up my KD36-74 today. It didn't take much force with a hammer against the shaft to pop the rear endbell off - and it's pressed in with epoxy like Feigao motors. Right now there is a crapload of JB Weld on it. The front endbell is actually threaded, but the threads on the cap are slightly too small of a diameter to properly fit into the threads on the can. When the rear endbell is done drying, I'll take some red threadlock to the front endbell.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|
Threaded Mode
