Alternative motor???

[lincpimp]

Originally Posted by lutach

Both the ones I have use one single magnet. It's a good thing to do is to open the motor and clean the magnet as I found some small peices of magnet stuck to the rotor. I might even go a bit crazy when the 2 correct motors comes in and wrap the magnet with either Kevlar, Carbon Fiber or some Spectra. The windings are basically the same as most Feigao and KD type motors.

In that case, I doubt it will be much better than a feigao. It will disapate heat better, and the can will not come apart as easy. Those are reason enough to buy this over a smooth, pressed endbell feigao.

[lutach]

Originally Posted by lincpimp

In that case, I doubt it will be much better than a feigao. It will disapate heat better, and the can will not come apart as easy. Those are reason enough to buy this over a smooth, pressed endbell feigao.

Yes, the extra material will help the motor with heat issues. The bad thing about the 45mm cans is that they won't fit my MBX5T. I'm afraid to try them in my BPP and the extra weight of the truck will probably be too much for the 1/8" shaft.

Can you post some pictures of the two ends of the motor? I would like to know how the endplates are bolted on.

[suicideneil]

Originally Posted by chumanji

Can you post some pictures of the two ends of the motor? I would like to know how the endplates are bolted on.

Assuming they are true clones, then the front is bolted on with 5 screws:



and 3 screws on the rear, spaced equally around the edge.

[Getter Robo]

Originally Posted by lutach

The bad thing about the 45mm cans is that they won't fit my MBX5T.

The shop also got motors which look just like the smooth can feigaos