e-maxx redneck mods

[Jason]

ok! I have see this one should work on my maxx :

http://www3.towerhobbies.com/cgi-bin...?&I=LXFUA5&P=7

it is mod1 right ?

[lincpimp]

Originally Posted by Jason

ok! I have see this one should work on my maxx :

http://www3.towerhobbies.com/cgi-bin...?&I=LXFUA5&P=7

it is mod1 right ?

It will work with a few mods. Open the center hole up with a reamer to match the slipper bearing. and you will also have to open up 3 of te smaller holes to fit over the slipper screw vosses so that the spur will fit flat on the slipper. Really easy, will take you 1-2 minutes, max.

[Jason]

ok cool and do I can match a 17t pinion on it without any trouble right ? since the stock e-maxx spur was 68t and this one 52t ( mod1 )

[lincpimp]

Originally Posted by Jason

ok cool and do I can match a 17t pinion on it without any trouble right ? since the stock e-maxx spur was 68t and this one 52t ( mod1 )

It should fit, as the 52t supr is larger in diameter than a 52t 32p spur would be. Your gearing will be higher, so the truck will be faster.

[Jason]

ok nice, anyone know other mod 1 spur gear from other rc brands that direct fit the e-maxx 3905 ?

[Jason]

because im not sure my hobby store have this monster gt spur in stock