hobbywing ezrun 150A vs Mamba monster

[tom255]

Does anybody run Ezrun 150/80A ESC with NEU's or CC2200 or CC2650 motors?
I have seen couple bad reports about NEU and Ezrun 150A and also my friend have problem with Ezrun 150A and Teckno NEU 1515 2700KV motor. Coging is noticeable.

He seriously think to sell this ESC unless coging can be fixed with firmware, he is ready to buy advanced programming card but nut sure does it fix... With feigao it runs as supposed.

[superek4]

Originally Posted by tom255

Does anybody run Ezrun 150/80A ESC with NEU's or CC2200 or CC2650 motors?
I have seen couple bad reports about NEU and Ezrun 150A and also my friend have problem with Ezrun 150A and Teckno NEU 1515 2700KV motor. Coging is noticeable.

He seriously think to sell this ESC unless coging can be fixed with firmware, he is ready to buy advanced programming card but nut sure does it fix... With feigao it runs as supposed.

I use a ez150amp with medusa motors no problem. Timing set to 8-11 no cogging.try changing the timing