Quote:
Originally Posted by lutach
Did the place that cut your chassis use just water or did they use any abrasive material? Here is a video that shows a nice piece of CF being cut using a water jet: http://www.youtube.com/watch?v=zI4QnWOwAys.
I do agree that cnc is the way to go. |
Yep, CNC is looking like the 'easier' way to get this done right. I also like the router option too... I really want to get this chassis done... It's my first real 'design'.
Quote:
Originally Posted by Arct1k
An option for you - use the laser but with a 3mm gap around the whole chassis and then sand in the rest.
For the holes just burn a tiny guide hole and then drill it out...
|
An idea, but the heat made the fibers/epoxy flash area so big (even with a mask), the frayed fibers were longer than 5mm.
Threaded Mode
