Quote:
Originally Posted by johnrobholmes
Use a Y harness that routes power from BEC to servo, and the extra lead goes to RX and passes only signal wire.
|
so I would need to remove the signal wire from the cc bec (orange) and only have the orange wire on the other side of the y harness? Leaving all the wires from the esc intact and plugged in normally? Or just hook up the black and red wire from the bec to the black and red to the servo and just plug the signal directly back into the reciever? Does the signal wire from the CC bec have to be plugged to something?
Threaded Mode
