CC Blower now on sale!

[Shark413]

I recieved a couple of them today and tried them out on various motors to see what they fit. One thing I noticed was it is basically a shroud and relies on the cans cooling fins for output venting. So smooth can motors may not vent as well, or I guess you could drill some holes, but I think the logic was to blow air around as much of the can as possible before venting.

Pictures:


Fits perfectly on a Neu-Castle


Fits on a finned Neu 1515 perfectly as well


And a finned Neu 1512 (same diameter)


Doesn't fit on a 1515 Tekno-Neu square can - Duh


Fits pretty good on a Tekin T8


Fits ok on a smooth can Neu 1509 (a little loose)


Worked ok on a Feigao


Too big for a Castle CMS36 can


Way too big for a 540 sized can


And the only output venting is via the ribs on the can.