Quote:
Originally Posted by RC-Monster Mike
Sorry about the missing pressure plate, Steeni. I am glad you had something similar layong around. The slipper side must be scuffed up a bit and also must be one that is included(they have cutouts that engage the slipper side endcap to prevent it from spinning). The 2 plates on either side of the thrust bearing are to provide a surface for the bearings - any washer in this size is fine here. :)
|
Np, as I said it's working now.
But I would say that the scuffing of the pressureplate on the slipperside is a must, the slipperential did overheat badly after roughly 3 minutes on the track before I actually read the instructions again
and saw the remark about the scuffing.
Hybrid Mode
