Quote:
Originally Posted by Gee
Nice job! I love to see the "Homemade" builds and ideas that people come up with. A part of the hobby I like probably the most. This looks like it is going to be real sweet! The flathead screws look nice. Could you recess them into carbon to sit flush or would that take too much away from the strength/integrity of the area?
|
Thanks man... This is really the part of the hobby I love too... I wanted to keep the heads of the screws on top because it adds a little something to the look of the chassis.
Quote:
Originally Posted by JThiessen
CF doesn't do well with tapered cross cuts in it, such as you'd get with a countersunk screw. They tend to delam faster when you do that. I'm speaking from an aircraft design standpoint - but I'm sure the same applies here. Not only that, but you'd dull your countersinks so fast you'd probably spend as much on them as you did on the CF plate. That stuff is really hard on bits.
|
Yep... that's correct I did a test counter sink with a spare piece of carbon and it didn't work out so well.
Threaded Mode
