 |
|
|
|
|
|
 |
|
|
 |
 |
|
 |
|
(#1)
|
|
"Out of spec" enthusiast
Offline
Posts: 820
Join Date: May 2005
|
11.17.2009, 10:07 PM
1/8" = 3.175mm. I can see where this could be going and it doesn't look pretty. You could save yourself a lot of pain by telling us what your plan is.
Sub 7lb, lowest CG of any 1/8 buggy http://www.rc-monster.com/forum/show...894#post367894 Area 52 Ranch Raceway T.R.C.R. |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
RC-Monster Stock
Offline
Posts: 12
Join Date: Nov 2009
|
11.17.2009, 10:11 PM
So it is possible to put the "2 Speed pinion adapter 5mm bore" on a 1/8" = 3.175mm shaft using the Bore Reducer and the pinion adapter?
Is this correct? http://www.rc-monster.com/proddetail...rcm2spdadapter |
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
