New Mamba software (beta) posted today

[kostaktinos_mt]

ok, here is my issue:

1.29 doesnt run at all. mamba max starts fine, beeps and all, then a red led flashes rapidly. no throttle response, no extra beeps, no nothing.

i flashed back to 1.28, problem solved.
flashed again to 1.29, same thing again. reloaded the settings, nothing changed. default settings, nothing changed. i pretty much tried everything.
1.28 works fine [other than the random startup hesitations], but 1.29 refuses to work.

any ideas?

[Lucariel]

Originally Posted by kostaktinos_mt

ok, here is my issue:

1.29 doesnt run at all. mamba max starts fine, beeps and all, then a red led flashes rapidly. no throttle response, no extra beeps, no nothing.

i flashed back to 1.28, problem solved.
flashed again to 1.29, same thing again. reloaded the settings, nothing changed. default settings, nothing changed. i pretty much tried everything.
1.28 works fine [other than the random startup hesitations], but 1.29 refuses to work.

any ideas?

same probrem...

new feature signal the over voltage in the esc..
is possible remove this

I use the sidewinder in the my 1/16 e-revo in 4s configuration....
is possible remove this

why this version not show the KV motor?

sorry for my bad english...
tanks in advance Luca

[suicideneil]

Over voltage detection feature is to prevent people from blowing up their escs by using them outside of specification.

The kv detection feature was removed to stop people from phoning up asking why their 2200kv neu motor was being reported as a 4400kv motor; the feature is designed for 2 pole motors, the user has to do the math based on how many poles their motor actually has = lots of stuid people didnt understand this and kept phoning up castlecreations to ask for help. No more kv feature = no more phone calls. The kv should be on the motor/ label anyway.

Roll the firmware back to an earlier version if you dont like the current features.