Misc parts Questions

[coolhandcountry]

Well you can put more in it but if it touches the windings it is not going to run right. it goes in only a few mm. Look at the end and see how thing it is.

[BrianG]

OK, thanks.

I think I will shorten some 10mm screws or something with a dremel like HotnCold suggested. It just floors me that there are only a couple mm's of threads across two screws holding these motors in place. Do screws ever break from the torque?

As for the cups; I asked Mike if he could add some MIP cups to my existing order for my custom dogbones, but he said they were already included! Yay! Good thing I didn't pick some up at my LHS!