1/6th Scale Savage Conversion

[Finnster]

Slight revision to my idea. Made two pages w/ ruler markings and parallel lines all the way across. Pages were overlapped and tvp traced w/ essential screw holes. Pages were then split and scanned separately. The new pages are easier to line up on the ruler markings, so new wheelbase is just made by sliding the pages along to the intended measurement.

The wheelbase I am getting on my XL is ~412mm kingpin to kingpin. Strange as the listed wheelbase is 390mm. My target wheelbase is 520mm. I need to slide the papers back ~110mm.

I made scans so I can just print these up, line them up and then overlay them onto my test material. I will need to trace out the new TVP design. The only critical areas are the screw holes and the bulkhead and skid plate fittings. Everything else is nego.