 |
|
|
|
|
|
 |
 |
 |
 |
|
|||||||
 |
 |
 |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
 |
 |
|
|
|
(#1)
|
|
working on a brushless for my wheelchair.....
Offline
Posts: 4,890
Join Date: Mar 2007
Location: minnesnowta
|
01.24.2011, 10:48 PM
air leak. check all fuel lines and tank connections. is the carb on tight? are you SURE you didn't get it hot during break in and burn the glow plug? or worse, lose compression? If you can spin the flywheel by a finger compression is lost and you need a rebuild. air leaks at the exhaust will cause these issues also.
when in doubt start with fresh fuel, fresh glow plug and new ffuel lines. It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper. |
|
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
