RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > General Nitro

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old
  (#3)
HotnCold
RC-Monster Admin
 
HotnCold's Avatar
 
Offline
Posts: 1,065
Join Date: Dec 2004
Location: RC-Monster Store....Where else?
04.16.2006, 06:20 AM

i have the revo with the 2.5R motor - 200 is too low of a temp - Did she shut off because of high temp - Did the idle race up and down before shutting down ? - i know that temps are ok when in the upper 200's - 300 is a bit high - i would say recheck all connections - make sure you didnt put a small hole in the fuel tubing - take apart stretch and plug one end and blow into the other - both lines from tank to pipe and tank to motor. Make sure your carb is not loose - make sure that you have no exhaust leaks - that will make you run lean quick. Do a once over on her - and retune it for about 260 or 280 - try that and keep an eye on it - I also had a problem with my RB .21 motor - the rubber gasket on the high side needle valve went bad - kept screwing in - hotter hotter - till we figured it out - check and make sure this is not a problem.. Youll figure her out....


Hows that "Hope and Change" working out for Ya???

Last edited by HotnCold; 04.16.2006 at 06:21 AM.
   
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com