|
04.29.2007, 07:44 PM
I haven't had too much experience with CF, but I have done a bit of work with Garolite G-10 (same "family" as CF). This stuff is quite tough on tools. On my scroll saw I would go through normal blades (that I use to cut aluminum with) after about 3 inches, at which point they were completely dull. I have also noticed that my countersinking bits aren't as sharp as they were before they hit the G-10.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
|
Threaded Mode
