Quote:
Originally Posted by Serum
i can't imagine that gives a good alligned wheel metalman;
the savage uses a 8mm shafts, and the revo uses a 6er. the flange on the savage adapters usually press against the part where the thread changes into 8mm shaft.
|
In my posted I stated that the hex is not a perfect fit with the wheel
off (no tension against the hex), but I had no problems with extra play at the wheels with the nut tightened all the way.
SH Z-Car, Custom Crawler, 8s Savage,
12s XTM XLB 1/7 buggy,
4wd 4-link rear/IFS Pro4 truck,
Custom Hyper 10 Short Course,
Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
Threaded Mode
