Medusa End Bell Dust Cover - RC-Monster Forums

RC-Monster Mike · 03.02.2009, 12:36 PM

I will have lengths for all Medusa motors - our existing "s" size already fits the 50mm Medusa motors, and our "L" size fits the 60mm Medusa.
I could easily make a rear plate/cover to fit these heatsinks and cover the rear holes(replace the bar used currently as a rear support). :)

magman · 03.02.2009, 12:40 PM

Quote:

Originally Posted by RC-Monster Mike

I will have lengths for all Medusa motors - our existing "s" size already fits the 50mm Medusa motors, and our "L" size fits the 60mm Medusa.
I could easily make a rear plate/cover to fit these heatsinks and cover the rear holes(replace the bar used currently as a rear support). :)

Mike that would be perfect! A rear cover combined w/the heat sink is just what the Dr. ordered and would fill 2 needs as well!

Jeremy1976 · 03.02.2009, 01:57 PM

I just need something to keep the dirt and crap out of it when it is mounted up to my Slash.

lincpimp · 03.02.2009, 02:06 PM

Quote:

Originally Posted by RC-Monster Mike

I will have lengths for all Medusa motors - our existing "s" size already fits the 50mm Medusa motors, and our "L" size fits the 60mm Medusa.
I could easily make a rear plate/cover to fit these heatsinks and cover the rear holes(replace the bar used currently as a rear support). :)

Could you also sell that part seperately? I must have 4-5 of your heatsinks and would like to use a l can model for the 60mm medusa...