 |
|
|
|
|
|
 |
 |
 |
|
 |
|
(#8)
|
|
RC-Monster Spudgunner
Offline
Posts: 2,353
Join Date: Apr 2008
Location: South Dakota
|
07.20.2009, 10:49 PM
DANG I just bent a rear one. It might have been me looking for dogbones when I had my outrunner setup... Blew both hpi dogbones!
 I went to an inrunner setup. Stupid me, after a ginormous jump over a trailer at full speed my gear mesh was off. I unbolted the center diff assembly to adjust the dang mesh. I think when I tossed it on the ground with the center diff assebly loose, it bent the rear shaft. DANG. I need new ones too, and I can't find any. |
  |
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
