My converted Losi 8T

[nitrostarter]

Not positive but I think the RC-M Heatsink for the Feigao's will work. May need longer screws for the "L" size also.

Very nice setup on the 8T. I love the color choice as well as the stance of it. Any bodies?

I had been thinking of doing an on-road Truggy using my 8T as well. Unfortunately I sold it, but it's not hard to find another good used one...

[Jesse M]

Thanks nitrostarter. I may have to try the Feigao clamp, but I did hear that Mike at RCM set aside a lot of money a while back to produce Medusa heatsinks/clamps. It would be nice to have a clamp that blocked both the front and rear vent holes on the Medusas. I don't want to use it in my Mutilator yet because I've heard of the end bells coming off and destroying the motor.

I do have a 1.0 body that I airbrushed, but I don't use it much because the motor and esc get a lot more airflow with it off. I'll try to post a picture with it on tonight sometime.

[Jesse M]

Finished balancing earlier this evening and the difference is amazing. I used lead tape at a local golf shop. With about half throttle holding it in the air, there is next to zero wobble or vibration. I used one of the rear A-arms/axle with brand new bearings on my Mutilator minus the dogbone to balance it-probably worked as good as the Hudy or Dynamite balancer but minus the cost.

[BL_RV0]

Looks awesome. This one slipped under my radar I guess.