RC-Monster Forums  

Go Back   RC-Monster Forums > RC-Monster Area > General Discussion

Reply
 
Thread Tools Rate Thread Display Modes
Does this look brand new?
Old
  (#1)
skellyo
RC-Monster Brushless
 
skellyo's Avatar
 
Offline
Posts: 2,466
Join Date: Jan 2006
Location: Florida
Does this look brand new? - 07.31.2009, 08:01 PM

I just picked this up from a guy on rctech who stated it was brand new.

Here's his pic:
http://s1015.photobucket.com/albums/...t=DSC00234.jpg

And here's some of the things I saw on the Tx when I got it:

Not too bad, but the corner shouldn't be skinned if it's new.


WTF is this stuff on it? At least he could have cleaned if he was trying to pass it off as new.


More scratches from obvious use.


And the best part...a damn burn mark on the top edge corner. How the F can you tell me it's new when it's got a F'ing burn on it?


I did power it up and test it out. It's obvious it's been used before. The settings have all been changed and you can easily see in the pics above there's no way it hasn't been used.

I haven't PM'ed the guy yet to let him know I'm pissed, but the dude has to know whoever he sold it to would realize it's not brand new.

I'm more pissed about being lied to than anything. I wouldn't have bought it had I known it wasn't new.

What do you guys think?
   
Reply With Quote
Old
  (#2)
rawfuls
roofles.
 
rawfuls's Avatar
 
Offline
Posts: 1,982
Join Date: Oct 2008
Location: Woodland Hills, CA
07.31.2009, 08:07 PM

That's hilarious that he posted brand new, but sucks for you, I'd be more pissed about him lying to you, straight up, when he has obvious signs of use..
  Send a message via AIM to rawfuls Send a message via MSN to rawfuls  
Reply With Quote
Old
  (#3)
suicideneil
Old Skool
 
suicideneil's Avatar
 
Offline
Posts: 7,494
Join Date: Feb 2007
Location: Devon, England
07.31.2009, 08:09 PM

Nearly new, only dropped on the BBQ during a sunday afternoon bash session once...

The grip doesnt have a built up of dead skin (yummy) or shinny surface from being gripped over time (like a stearing wheel on a 1:1), but it clearly looks like its been used an dropped a few times. Even if it was just a couple times, there is a big difference between new vs nearly new.
   
Reply With Quote
Old
  (#4)
maxair45
RC-Monster Carbon Fiber
 
maxair45's Avatar
 
Offline
Posts: 371
Join Date: Jul 2008
07.31.2009, 08:56 PM

You should just have this reflect in his Itrader feedback and contact him on possibly getting some money back because one he lied and two its used. Did he send you pics of it before you guys finialized the deal?
   
Reply With Quote
Old
  (#5)
rchippie
RC-Monster Brushless
 
rchippie's Avatar
 
Offline
Posts: 2,824
Join Date: Apr 2005
Location: largo fl
08.01.2009, 12:07 AM

I would be pissed if i recived that if he said it was new . Depending how good the deal you recived was . I would either try & get some money back or leave him negitive feedback .


REAL MEN RUN BRUSHLESS

Last edited by rchippie; 08.01.2009 at 12:09 AM.
   
Reply With Quote
Old
  (#6)
lincpimp
Check out my huge box!
 
lincpimp's Avatar
 
Offline
Posts: 11,935
Join Date: Aug 2007
Location: Slidell, LA
08.01.2009, 01:19 AM

I suggest public stoning...
   
Reply With Quote
Old
  (#7)
Snipin_Willy
RC-Monster Carbon Fiber
 
Snipin_Willy's Avatar
 
Offline
Posts: 406
Join Date: Aug 2008
08.01.2009, 01:27 AM

I will never ever ever ever ever again expect new when buying from anyone other than a supplier. I got this sorta thing when I bought my DX3 a couple years ago. Was said to be in good condition. When it arrived it was terrible. Even the charge the seller sent with it wasn't ment for the spektrum radios. The guy took the sticker off the original spektrum charger and put it on the back of a dynamite wall charger. The guy obviously didn't see the polarity difference between the two wall chargers. I left the guy way negative feedback.
   
Reply With Quote
Old
  (#8)
suicideneil
Old Skool
 
suicideneil's Avatar
 
Offline
Posts: 7,494
Join Date: Feb 2007
Location: Devon, England
08.01.2009, 11:23 AM

I would confront him with your own pictures, see what he says. If he stone walls you or pleads ignorance, then leave bad feed back, and spread the word. Could have been alot worse, but like I said new vs nearly new is not the same thing- dishonesty is bad when selling items, even if its a small issue.
   
Reply With Quote
Old
  (#9)
simplechamp
RC-Monster Titanium
 
simplechamp's Avatar
 
Offline
Posts: 1,884
Join Date: Jul 2009
08.01.2009, 11:33 AM

I agree with others, it's not even the dings and scratches as much as it is the dishonesty. If he lied about it being new what else has happened to the radio? Pricewise too, when I buy something used (even used only once) I'm willing to pay much less than if it were new.

I'd leave him negative feedback regardless of what he says or does to try and make up for it. Teach him a lesson.
   
Reply With Quote
Old
  (#10)
What's_nitro?
Soldermaster Extraordinaire
 
What's_nitro?'s Avatar
 
Offline
Posts: 4,529
Join Date: Apr 2007
Location: Plymouth, MA, USA
08.01.2009, 12:02 PM

Quote:
Originally Posted by rchippie View Post
I would be pissed if i recived that if he said it was new . Depending how good the deal you recived was . I would either try & get some money back or leave him negitive feedback .
+2
   
Reply With Quote
Old
  (#11)
RCShocker
RC Monster
 
Offline
Posts: 460
Join Date: Jan 2007
Location: Charlotte, NC
08.01.2009, 01:19 PM

I would definately let him know that you are pissed and dont appreciate him bending the truth quite a bit.

I would hope that he would offer to buy it back and apologize. At the very least maybe $50-$75 cash back for his indiscretion and the fact that used goes for much less. Hard to say not knowing what you paid. That's your business.

I would start throwing the liar & loser stuff around/negative feedback until at least he had the chance to offer a reply or an excuse.

The "cigarette-looking" burn AND dishonesty are what would have pissed me off the most.

Best of luck Sean.

Last edited by RCShocker; 08.01.2009 at 01:25 PM.
   
Reply With Quote
Old
  (#12)
skellyo
RC-Monster Brushless
 
skellyo's Avatar
 
Offline
Posts: 2,466
Join Date: Jan 2006
Location: Florida
08.01.2009, 08:57 PM

I'm not super pissed about the $. It was $60 shipped, so it would have been a great deal had it been new.

FWIW, I have PM'ed him about the issues with the radio. He said he didn't see the burn mark on it. How the hell can you not see it?

Right now I'm debating about whether or not to leave him negative feedback or not. He has not even offered any compensation for the blemishes on the radio. A simple offer of $5-10 would probably get me leaning towards a neutral instead of a negative.
   
Reply With Quote
Old
  (#13)
BP-Revo
BMW M Power!
 
BP-Revo's Avatar
 
Offline
Posts: 1,910
Join Date: Jan 2006
Location: SoCal
08.01.2009, 09:14 PM

Ok, "so he didn't see the burn mark." Big deal.

What about the fact that he said it was new while it was obviously used? Stating "brand new" and "like new" are two *completely* different things.

You should ask him again about the other stuff, pressing that him simply stating he didn't see the burn mark does not fix things and that you are still pissed.


BL Revo: CF G2R, LMT1940/7, 6S FP 30C Lipos, MMM, Hitec 5955TG
CRT .5: 7075 Ext Chassis, LMT1930/7, FP 25C 3S Lipos, MM
   
Reply With Quote
Old
  (#14)
shaunjohnson
i pwn nitro
 
shaunjohnson's Avatar
 
Offline
Posts: 769
Join Date: Nov 2008
Location: with ur GF
08.01.2009, 09:16 PM

i know i'd be super pissed off!!
i'd tell him exactly what i thought, showed him your own pics, demanded a re-fund and then leave him way neg feedback and report him to ebay/whateversiteitwas.
we had a case like this my way.
friend brought a mamba max from ebay, it said the wire had been upgraded and such.
it didnt work, dead short, and the so called wire upgrade...well you guys would have died of shock at the sight of the soldering!!
demanded a re-fund and told him it was simply the crapest soldering ive ever seen..and then we got a total re-fund and got to keep the MM (cause it wasnt worth sending it back) and then promptly mailed it off to castle.


E-revo 3.3 conversion, 249kv outrunner, 6s, MMM
the porthole from the noob world an here has been opened!! that's how i got in.
  Send a message via MSN to shaunjohnson  
Reply With Quote
Old
  (#15)
rschoi_75
Certified Spaceball
 
rschoi_75's Avatar
 
Offline
Posts: 675
Join Date: Jun 2007
Location: CA
08.02.2009, 01:41 PM

what's his user name? He is obviously a person to be avoided when dealing on rctech.


There's two sides to every schwartz, he got the up side and I got the down side.

rcm xt8
rcm xb8
rcm crt.5
   
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com